Description
The mechanical seal sits on the pump shaft and keeps water from reaching the motor. This kit has two parts (visible in the photos) and is intended for the pumps of Azuro 5, Azuro EM 5 and G S144T. Like the Glong FCP-250S 5 m³/h pump, it is an element of the filtration system.
Technical data
| Part number | GL250S22 |
|---|---|
| Brand | Mountfield |
| Category | shaft seal (mechanical) |
| Parts in the kit | 2 |
| Pump of models | Azuro 5, Azuro EM 5 and G S144T |
Compatibility by code
- G S144T has code 3BTE0418
- Azuro EM 5 has code 3BTE0521
- Azuro 5 has code 3BTE0542
If you do not know which pump your filter has, look for the plate on the motor.
Why it wears out first
While the pump is running, the seal is in constant action, so it is among the first parts to wear. The warning sign is water under the pump. If you do not react, moisture reaches the motor bearings and the repair becomes much more expensive.
When to replace it
- water drips from the base of the pump
- noise comes from the shaft
- the pump is being overhauled
The two parts are always replaced together so that they wear evenly.
Installation
Disconnect the pump from the mains and drain the water. Remove the housing and the impeller, take out the old seal and clean its seat. Fit the new parts clean, and do not touch their flat surfaces with your fingers. Reassemble the pump and watch for leaks when you start it.
The pump must never run dry – even briefly, this damages the new seal. Before every start, check that the strainer has water in it. On an older pump, also replace the sealing rings during the same disassembly. After installation, let it run for a few minutes; if a drop appears, stop and check the position of the two parts.
While the pump is taken apart, also inspect the strainer basket.
See also: Wellness, Pools and Equipment, Spare and Other Parts, Pool Spare Parts, For Filters and Other Equipment, For Prefabricated Pools, Pool Liners, Pool Underlays.
























