Description
Want a clean pool floor without dragging hoses and cables around? The black Aiper Scuba SE is a lightweight cordless robot built for exactly that – for liner pools of up to 80 m² with a smooth, flat floor.
The model at a glance
- Purpose: cleaning the floor of pools with PVC membrane (liner) and a flat bottom.
- Coverage: area up to 80 m² and length up to 9 m, depth up to 1.50 m.
- Runtime: up to 90 minutes per charge (up to 100 minutes in some modes and conditions).
- Filter basket with a 2 L capacity and a mesh of up to 180 microns.
- Body colour: black.
How the Scuba SE works
All it takes is a press of the button and dropping the machine into the water – it sets off across the floor and collects the dirt for as long as the battery lasts, up to about an hour and a half.
The motor unit has two motors – one for the pump and one for the drive. The pump draws 75 L of water per minute (1200 GPH, or 4500 L/h), and the water passes through the basket, where sand, dust, leaves and insects are left behind.
The streamlined body saves energy on movement, so more of the battery goes into the cleaning itself. In a single cycle the robot covers the floor of a small or medium pool, and when the job is done or the charge runs low, it heads to the wall on its own and stops there.
Convenience in everyday use
- No cables: no tangling, no tripping hazard, and the robot is easy to put away.
- One-touch start (One-Click Activation): switch it on, lower it into the water and it begins on its own.
- Audible notifications: you hear when it is working, when it is done and when it needs charging.
- Fast drainage: after cleaning, up to 80% of the retained water drains out in about 15 seconds, so it can be lifted out with one hand.
- Automatic parking: it stops by the wall or the edge, so even in a deeper pool you do not have to get into the water.
- Short charging time: about 3 hours to a full charge.
Technical specifications
| Manufacturer | Aiper |
|---|---|
| Model | Scuba SE (black), manufacturer code X1 |
| Power supply | Cordless, rechargeable battery |
| Cleaning area | Floor only (flat, liner only, no tiles) |
| Pools up to | 80 m², length 9 m |
| Max. depth | 1.50 m |
| Runtime | up to 90 minutes (90–100 min) |
| Charging time | about 3 hours |
| Suction | 1200 GPH (4500 L/h) |
| Filter | Fine mesh up to 180 microns |
| Basket | 2 L |
| Motors | 1 pump + 1 drive |
| Water conditions | 15–35 °C; pH between 7.0 and 7.6; free chlorine 4 ppm at most; salt 0.4% at most |
| Weight | 4.5 kg |
| Dimensions (L × W × H) | 41.5 × 32.6 × 20 cm |
Is it right for your pool
The robot is intended for above-ground and in-ground pools with a PVC membrane and a flat floor. Do not choose it for a surface of tiles, mosaic, stone or another hard, rough finish – it has difficulty moving across such surfaces. It does not clean walls.
Frequently asked questions
Can it clean the walls? No, the model works on the floor only.
What is the difference between the black and the white one? Only the colour; the technical data are identical.
What does the robot need for a long life? Keep the water within the limits given above and empty the basket after cleaning.
